Rotary Shaft -Slip Ring [ 01324 ]
![Rotary Shaft -Slip Ring [ 01324 ]](/files/cache/280f35bfc14d1c98bfeff8683c404105.jpg)
These sensors are designed to measure rotating drive torque using a conventional shaft-to-shaft configuration for in-line placement. The design incorporates a coin silver slip ring assembly that transmits excitation voltage to, and output signals from, the rotating sensor. These sensors can be supplied with Auto-ID, which eliminates scaling when used with the PTI or PMAC 2000 instruments. An optical encoder to measure angle or speed is also available with this model.
OPTIONS:
• 4 pin Bendix connector (non Auto-ID)
• 10 pin Bendix connector (Auto-ID)
• Integrated signal amplifier (+/-5V or +/-10V)
• Integral optical encoder - 1024 ppr and 1500 ppr (requires 10 pin connector)
• Footmount
SPECIFICATIONS
Capacity ..................... 50 in. oz. to 20,000 in.lb. (See chart)
Overload capacity ........................................... 150% of F.S.
Output at F.S. .......................................2.0 mV/V nominal
Non-linearity ................................................... 0.10% of F.S.
Hysteresis ...................................................... 0.10% of F.S.
Zero balance .................................................. 1.00% of F.S.
Compensated temperature ............................. 70 to 170°F
Useable temperature .................................... -65 to +250°F
Temperature effect on zero .................. 0.002% of F.S./°F
Temperature effect on span ............... 0.002% of Rdg./°F
Bridge resistance ............................................. 1000 Ohms
Excitation voltage, maximum ................................. 20 Vdc
Maximum shaft speed ...................................... 5000 RPM*
*For faster shaft speeds and different end configurations, please contact the factory. Mating connector supplied.